Anker Charger – 100W three-port GaN charger with smart display

Anker Charger (100W, 3 Ports, Smart Display) is a wall charger for powering a laptop, smartphone and smaller USB-chargeable accessories from one unit. Two USB-C ports and one USB-A port support simultaneous charging of up to three devices, with a maximum total output of 100W. GaN technology and an integrated smart display combine high output with direct access to key charging information.

Up to 100W from a single USB-C port

USB-C1 and USB-C2 each provide up to 100W when used individually. Both ports offer fixed output modes of 5V / 3A, 9V / 3A, 15V / 3A and 20V / 5A. USB-A supports up to 33W, with output modes of 5V / 3A, 9V / 2A, 12V / 1.5A, 10V / 2.25A and 11V / 3A.

Reaching maximum charging power requires a connected device and cable that support the corresponding charging mode. Actual power also depends on battery level, device operating conditions and temperature. A 100W rating therefore does not mean every phone or laptop will continuously charge at that power.

Power distribution for two or three devices

Anker Charger distributes available power across ports when multiple devices are connected. Using both USB-C ports normally provides up to 70W + 30W. Combining a USB-C port with USB-A provides up to 67W + 33W. With all three ports in use, USB-C1 delivers up to 80W, USB-C2 up to 12W and USB-A up to 7.5W.

When a low-current device is connected to USB-C2 or USB-A, the charger can switch to an allocation of up to 95W + 5W under suitable conditions. According to Anker, this takes approximately one minute when the lower-power connection meets low-current requirements, typically below 6V and 1A. This allocation suits combinations such as a laptop and earbuds. Switching between two-port and three-port use may briefly interrupt charging while power is redistributed.

Smart display with rotating screen orientation

An integrated display shows real-time charging power, voltage and temperature, allowing you to monitor port operation. A short press switches display views, while a long press rotates screen orientation by 90°. The charger remembers your last screen orientation and restores it when powered on again.

ActiveShield 4.0 monitors temperature over one million times a day. Temperature regulation forms part of charging management, and temperature can affect actual charging power.

Compatibility and included cable

Anker lists MacBook Air and MacBook Pro series, HP Chromebook 14, iPhone 12–16 and SE series, Samsung Galaxy S23 and S24 series, Google Pixel 7 and 8 phones, and Steam Deck among compatible devices. Charging earbuds, smartwatches and other accessories requires a cable or charging accessory suitable for the specific device.

Input is 100–240V AC at 50/60Hz, with a maximum input current of 2.3A. This is a mains-powered charger rather than a power bank. An approximately 1.5m USB-C to USB-C cable is included for connecting a device with a USB-C charging interface.

See the full selection of cables and chargers here.